Shaker Slate Pre-Assembled Kitchen Cabinets

MATERIAL:  Birch & Maple

STYLE: Full Overlay, Butt Doors

WALL & BASE: 5-Piece Recess Square

FACE FRAME: 3/4" Thick Solid Birch

DOOR FRAME: 3/4" Birch

DOOR CENTER: Recessed Maple Veneer

SIDES (WALL/BASE): 1/2" A-Grade Plywood With Wood Veneer/Stained Finish

TOP & BOTTOM (WALL): 1/2" A-Grade Plywood/Wood Veneer

BOTTOM (BASE): 3/8" A-Grade Plywood With Wood Veneer

CABINET INTERIOR: Matches Door Color

BACK PANEL: 

• Wall Cabinets: 1/2" Picture Frame Recess Style
• Base Cabinets: Full Back Style

CONNECTORS: Pre-Installed, Color Coated  Metal Clip, Won't Tarnish

SHELVES: 3/4" A-Grade Plywood With Wood Veneer

BASE SHELF: 1/2 Depth

SHELF SUPPORTS: Metal

DRAWER BOX SIDES: 17mm (Close To 3/4") Hardwood

DRAWER BOTTOM: 1/2" Plywood

DRAWER LENGTH: 21"

DRAWER CONSTRUCTION: Dovetail

DRAWER FINISH: Natural UV Finish

DRAWER GLIDES: Undermount, Full Extension, Soft-Close

BASE SUPPORT: Wood Corner Brackets With Wood I-Beam

TOE KICK: 

• Individual Base Cabinets Com With 1/2" Plywood Finished Toe Kick

1. When using two or more cabinets in a run you will need to order 96" toe kick molding to run over the front & cover the seams between the cabinets where the individual toe board backer (toe kick) meets.

FINISH: Sherwin Williams Finish

EPA TSCA TITLE VI COMPLIANT

No Center Stile On 24"-36" Cabinets Unless Noted In Product

• Full-overlay door styles leave roughly a 1/4" clearance on the edge. If installed directly against a wall or deeper cabinet and a cabinet door opening of at least 90 degrees is desired, scribe molding should be installed between the cabinet and the wall (or deeper cabinet). If not, the door may not be able to open a full 90 degrees. For a full opening, a space of at least 1/4-1/2" is necessary, a larger space may be needed depending on the decorative hardware used on the cabinets.
• The cabinet depth measurement listed is the depth from the front of the face frame to the back of the cabinet, and does not include the cabinet door depth.
• Cabinet specs are subject to change without notice. *Cabinet measurements are typically converted from metric to inches and manufacturers will commonly round up to the nearest 1/4 inch. This can cause a measurement to be off by a fraction of an inch (less than 1/4") which is within normal industry standards*
• Schematic images are generic and may not represent exact construction details for each collection. The exact specifications for this collection can be found in the construction details listed above.